Soldering station how to troubleshooting?
The heater lamp does not light up.
[Check 1.]
Is the power cord and/or connecting plug disconnected ?
Connect it.
[Check 2.]
Is the fuse blown?
Determine why the fuse blew and eliminate the cause,then replace the fuse.
(1)Is the inside of the iron short-circuited?
(2)Is the grounding spring touching the heating element?
(3)Is the heating element lead twisted and short-circuited?
Problem2.
The heater lamp does not light up but the tip does not heat up.
[Check 3.]
Is the soldering iron cord broken ?
a.Refer to”Checking for breakage in the cord assembly”
[Check 4.]
Is the Heating Element broken?
Refer to “Checking for breakage in the heating element”
Problem3.
The tip heats up intermittently .
[Check 3.]
Problem 4.
The tip is not wet.
[Check 5.]
Is the tip temperature too high?
a.Set an appropriate temperature.
[Check 6.]
Is the tip clean?
Refer to”Tip Care and Use”
Problem 5.
The tip is not wet.
[Check 7.]
Is the tip coated with oxide?
a.Refer to “Insect and clean the tip”
[Check 8.]
Is the iron calibrated correctly?
a.Re-calibrate.
Problem 6.
The tip cannot be pulled off.
[Check 9.]
Is the tip seized?
Is the tip swollen because of deterioration?
a.Replace the tip and the heating element.
The heater lamp does not light up.
[Check 1.]
Is the power cord and/or connecting plug disconnected ?
Connect it.
[Check 2.]
Is the fuse blown?
Determine why the fuse blew and eliminate the cause,then replace the fuse.
(1)Is the inside of the iron short-circuited?
(2)Is the grounding spring touching the heating element?
(3)Is the heating element lead twisted and short-circuited?
Problem2.
The heater lamp does not light up but the tip does not heat up.
[Check 3.]
Is the soldering iron cord broken ?
a.Refer to”Checking for breakage in the cord assembly”
[Check 4.]
Is the Heating Element broken?
Refer to “Checking for breakage in the heating element”
Problem3.
The tip heats up intermittently .
[Check 3.]
Problem 4.
The tip is not wet.
[Check 5.]
Is the tip temperature too high?
a.Set an appropriate temperature.
[Check 6.]
Is the tip clean?
Refer to”Tip Care and Use”
Problem 5.
The tip is not wet.
[Check 7.]
Is the tip coated with oxide?
a.Refer to “Insect and clean the tip”
[Check 8.]
Is the iron calibrated correctly?
a.Re-calibrate.
Problem 6.
The tip cannot be pulled off.
[Check 9.]
Is the tip seized?
Is the tip swollen because of deterioration?
a.Replace the tip and the heating element.
Related News
- The Comparison And Development Dire...
- There Are Two Main Types Of Dc Stab...
- Application Range And Characteristi...
- Inspection Method Of Pressure Tester.
- Voltage Tester With Different Stand...
- Test Analysis Of Pressure Tester
- What Is A Pressure Tester
- Measurement Method Of Conduction In...
- You Have To Know About Oscilloscope...
- The Five Major Trend Analysis Oscil...
- How To Replace Soldering Station He...
- 30v 10a Dc Power Supply Promotion
- Hot Air Soldering Station Promotion...
- Dragon Boat Festival Holiday
- New Design Of Dc Power Supply 30v 5a
- Programmable Power Supply Of Custom...
- 30v 10a Power Supply